ENGR00161314-1 mx6q usb-host: add hsic support

MSL part

Add HSIC support for Host2 and Host3, for HSIC mode, there
is not usb phy needed, the usb device is always at the board

- Validation hardware: iMX6Q Validation Port Card and Re-worked
Rev X3 board, for hardware rework detail, contact Ken Sun (b03826)

- Validation device: HSIC interface SMSC HUB(USB4640) and Host 3.
Host 2 is coding finishes, but not verified due to hardware limitation.

- Pin Conflict with Ethernet, order to use HSIC, the user need
disable ethernet function at both u-boot and linux kernel.
For u-boot: please undefine CONFIG_MXC_FEC at your board config file
For kernel: please define CONFIG_USB_EHCI_ARC_HSIC, the entry is:
Device Drivers---> USB support---> Support HSIC Host controller
for Freescale SoC

- Suspend/resume and wakeup are not supported due to IC issues,
these IC issues will be fixed at TO1.1 for i.mx6, software will
add these support after receiving TO1.1 chip.

Signed-off-by: Peter Chen <peter.chen@freescale.com>

1 files changed, 1 insertions, 1 deletions

diff --git a/arch/arm/mach-mx6/Makefile b/arch/arm/mach-mx6/Makefile
index c0d9a855d844..7b3231f88647 100644
--- a/arch/arm/mach-mx6/Makefile
+++ b/arch/arm/mach-mx6/Makefile
@@ -3,7 +3,7 @@
 #
 
 # Object file lists.
-obj-y   := cpu.o mm.o system.o devices.o dummy_gpio.o irq.o bus_freq.o usb_dr.o usb_h1.o pm.o cpu_op-mx6.o mx6_wfi.o mx6_anatop_regulator.o
+obj-y   := cpu.o mm.o system.o devices.o dummy_gpio.o irq.o bus_freq.o usb_dr.o usb_h1.o usb_h2.o usb_h3.o pm.o cpu_op-mx6.o mx6_wfi.o mx6_anatop_regulator.o
 
 obj-$(CONFIG_ARCH_MX6) += clock.o mx6q_suspend.o
 obj-$(CONFIG_MACH_MX6Q_ARM2) += board-mx6q_arm2.o