summaryrefslogtreecommitdiff
path: root/drivers/net/wireless/iwlwifi/iwl-eeprom.h
diff options
context:
space:
mode:
authorJohannes Berg <johannes.berg@intel.com>2011-04-05 09:41:49 -0700
committerJohn W. Linville <linville@tuxdriver.com>2011-04-07 15:49:41 -0400
commit3240cab3ddfb2637cfca3a078078cdeda44d0a99 (patch)
treec7947465a10490d184533e337b06c862574781d7 /drivers/net/wireless/iwlwifi/iwl-eeprom.h
parent68e022dfeb548b48635888d1392f983977293573 (diff)
iwlagn: clean up some 3945/4965 remnants
When the driver was split, a bunch of definitions for the 3945 and 4965 devices stayed around, but they're now useless so remove (some of) them. Signed-off-by: Johannes Berg <johannes.berg@intel.com> Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com> Signed-off-by: John W. Linville <linville@tuxdriver.com>
Diffstat (limited to 'drivers/net/wireless/iwlwifi/iwl-eeprom.h')
-rw-r--r--drivers/net/wireless/iwlwifi/iwl-eeprom.h185
1 files changed, 0 insertions, 185 deletions
diff --git a/drivers/net/wireless/iwlwifi/iwl-eeprom.h b/drivers/net/wireless/iwlwifi/iwl-eeprom.h
index 98aa8af01192..d0f858af30e8 100644
--- a/drivers/net/wireless/iwlwifi/iwl-eeprom.h
+++ b/drivers/net/wireless/iwlwifi/iwl-eeprom.h
@@ -110,10 +110,6 @@ enum {
};
/* SKU Capabilities */
-/* 3945 only */
-#define EEPROM_SKU_CAP_SW_RF_KILL_ENABLE (1 << 0)
-#define EEPROM_SKU_CAP_HW_RF_KILL_ENABLE (1 << 1)
-
/* 5000 and up */
#define EEPROM_SKU_CAP_BAND_POS (4)
#define EEPROM_SKU_CAP_BAND_SELECTION \
@@ -168,28 +164,6 @@ struct iwl_eeprom_enhanced_txpwr {
s8 mimo3_max;
} __packed;
-/* 3945 Specific */
-#define EEPROM_3945_EEPROM_VERSION (0x2f)
-
-/* 4965 has two radio transmitters (and 3 radio receivers) */
-#define EEPROM_TX_POWER_TX_CHAINS (2)
-
-/* 4965 has room for up to 8 sets of txpower calibration data */
-#define EEPROM_TX_POWER_BANDS (8)
-
-/* 4965 factory calibration measures txpower gain settings for
- * each of 3 target output levels */
-#define EEPROM_TX_POWER_MEASUREMENTS (3)
-
-/* 4965 Specific */
-/* 4965 driver does not work with txpower calibration version < 5 */
-#define EEPROM_4965_TX_POWER_VERSION (5)
-#define EEPROM_4965_EEPROM_VERSION (0x2f)
-#define EEPROM_4965_CALIB_VERSION_OFFSET (2*0xB6) /* 2 bytes */
-#define EEPROM_4965_CALIB_TXPOWER_OFFSET (2*0xE8) /* 48 bytes */
-#define EEPROM_4965_BOARD_REVISION (2*0x4F) /* 2 bytes */
-#define EEPROM_4965_BOARD_PBA (2*0x56+1) /* 9 bytes */
-
/* 5000 Specific */
#define EEPROM_5000_TX_POWER_VERSION (4)
#define EEPROM_5000_EEPROM_VERSION (0x11A)
@@ -282,90 +256,6 @@ struct iwl_eeprom_enhanced_txpwr {
/* 2.4 GHz */
extern const u8 iwl_eeprom_band_1[14];
-/*
- * factory calibration data for one txpower level, on one channel,
- * measured on one of the 2 tx chains (radio transmitter and associated
- * antenna). EEPROM contains:
- *
- * 1) Temperature (degrees Celsius) of device when measurement was made.
- *
- * 2) Gain table index used to achieve the target measurement power.
- * This refers to the "well-known" gain tables (see iwl-4965-hw.h).
- *
- * 3) Actual measured output power, in half-dBm ("34" = 17 dBm).
- *
- * 4) RF power amplifier detector level measurement (not used).
- */
-struct iwl_eeprom_calib_measure {
- u8 temperature; /* Device temperature (Celsius) */
- u8 gain_idx; /* Index into gain table */
- u8 actual_pow; /* Measured RF output power, half-dBm */
- s8 pa_det; /* Power amp detector level (not used) */
-} __packed;
-
-
-/*
- * measurement set for one channel. EEPROM contains:
- *
- * 1) Channel number measured
- *
- * 2) Measurements for each of 3 power levels for each of 2 radio transmitters
- * (a.k.a. "tx chains") (6 measurements altogether)
- */
-struct iwl_eeprom_calib_ch_info {
- u8 ch_num;
- struct iwl_eeprom_calib_measure
- measurements[EEPROM_TX_POWER_TX_CHAINS]
- [EEPROM_TX_POWER_MEASUREMENTS];
-} __packed;
-
-/*
- * txpower subband info.
- *
- * For each frequency subband, EEPROM contains the following:
- *
- * 1) First and last channels within range of the subband. "0" values
- * indicate that this sample set is not being used.
- *
- * 2) Sample measurement sets for 2 channels close to the range endpoints.
- */
-struct iwl_eeprom_calib_subband_info {
- u8 ch_from; /* channel number of lowest channel in subband */
- u8 ch_to; /* channel number of highest channel in subband */
- struct iwl_eeprom_calib_ch_info ch1;
- struct iwl_eeprom_calib_ch_info ch2;
-} __packed;
-
-
-/*
- * txpower calibration info. EEPROM contains:
- *
- * 1) Factory-measured saturation power levels (maximum levels at which
- * tx power amplifier can output a signal without too much distortion).
- * There is one level for 2.4 GHz band and one for 5 GHz band. These
- * values apply to all channels within each of the bands.
- *
- * 2) Factory-measured power supply voltage level. This is assumed to be
- * constant (i.e. same value applies to all channels/bands) while the
- * factory measurements are being made.
- *
- * 3) Up to 8 sets of factory-measured txpower calibration values.
- * These are for different frequency ranges, since txpower gain
- * characteristics of the analog radio circuitry vary with frequency.
- *
- * Not all sets need to be filled with data;
- * struct iwl_eeprom_calib_subband_info contains range of channels
- * (0 if unused) for each set of data.
- */
-struct iwl_eeprom_calib_info {
- u8 saturation_power24; /* half-dBm (e.g. "34" = 17 dBm) */
- u8 saturation_power52; /* half-dBm */
- __le16 voltage; /* signed */
- struct iwl_eeprom_calib_subband_info
- band_info[EEPROM_TX_POWER_BANDS];
-} __packed;
-
-
#define ADDRESS_MSK 0x0000FFFF
#define INDIRECT_TYPE_MSK 0x000F0000
#define INDIRECT_HOST 0x00010000
@@ -398,83 +288,8 @@ struct iwl_eeprom_calib_info {
#define EEPROM_RF_CFG_TX_ANT_MSK(x) ((x >> 8) & 0xF) /* bits 8-11 */
#define EEPROM_RF_CFG_RX_ANT_MSK(x) ((x >> 12) & 0xF) /* bits 12-15 */
-#define EEPROM_3945_RF_CFG_TYPE_MAX 0x0
-#define EEPROM_4965_RF_CFG_TYPE_MAX 0x1
-
-/* Radio Config for 5000 and up */
-#define EEPROM_RF_CONFIG_TYPE_R3x3 0x0
-#define EEPROM_RF_CONFIG_TYPE_R2x2 0x1
-#define EEPROM_RF_CONFIG_TYPE_R1x2 0x2
#define EEPROM_RF_CONFIG_TYPE_MAX 0x3
-/*
- * Per-channel regulatory data.
- *
- * Each channel that *might* be supported by iwl has a fixed location
- * in EEPROM containing EEPROM_CHANNEL_* usage flags (LSB) and max regulatory
- * txpower (MSB).
- *
- * Entries immediately below are for 20 MHz channel width. HT40 (40 MHz)
- * channels (only for 4965, not supported by 3945) appear later in the EEPROM.
- *
- * 2.4 GHz channels 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14
- */
-#define EEPROM_REGULATORY_SKU_ID (2*0x60) /* 4 bytes */
-#define EEPROM_REGULATORY_BAND_1 (2*0x62) /* 2 bytes */
-#define EEPROM_REGULATORY_BAND_1_CHANNELS (2*0x63) /* 28 bytes */
-
-/*
- * 4.9 GHz channels 183, 184, 185, 187, 188, 189, 192, 196,
- * 5.0 GHz channels 7, 8, 11, 12, 16
- * (4915-5080MHz) (none of these is ever supported)
- */
-#define EEPROM_REGULATORY_BAND_2 (2*0x71) /* 2 bytes */
-#define EEPROM_REGULATORY_BAND_2_CHANNELS (2*0x72) /* 26 bytes */
-
-/*
- * 5.2 GHz channels 34, 36, 38, 40, 42, 44, 46, 48, 52, 56, 60, 64
- * (5170-5320MHz)
- */
-#define EEPROM_REGULATORY_BAND_3 (2*0x7F) /* 2 bytes */
-#define EEPROM_REGULATORY_BAND_3_CHANNELS (2*0x80) /* 24 bytes */
-
-/*
- * 5.5 GHz channels 100, 104, 108, 112, 116, 120, 124, 128, 132, 136, 140
- * (5500-5700MHz)
- */
-#define EEPROM_REGULATORY_BAND_4 (2*0x8C) /* 2 bytes */
-#define EEPROM_REGULATORY_BAND_4_CHANNELS (2*0x8D) /* 22 bytes */
-
-/*
- * 5.7 GHz channels 145, 149, 153, 157, 161, 165
- * (5725-5825MHz)
- */
-#define EEPROM_REGULATORY_BAND_5 (2*0x98) /* 2 bytes */
-#define EEPROM_REGULATORY_BAND_5_CHANNELS (2*0x99) /* 12 bytes */
-
-/*
- * 2.4 GHz HT40 channels 1 (5), 2 (6), 3 (7), 4 (8), 5 (9), 6 (10), 7 (11)
- *
- * The channel listed is the center of the lower 20 MHz half of the channel.
- * The overall center frequency is actually 2 channels (10 MHz) above that,
- * and the upper half of each HT40 channel is centered 4 channels (20 MHz) away
- * from the lower half; e.g. the upper half of HT40 channel 1 is channel 5,
- * and the overall HT40 channel width centers on channel 3.
- *
- * NOTE: The RXON command uses 20 MHz channel numbers to specify the
- * control channel to which to tune. RXON also specifies whether the
- * control channel is the upper or lower half of a HT40 channel.
- *
- * NOTE: 4965 does not support HT40 channels on 2.4 GHz.
- */
-#define EEPROM_4965_REGULATORY_BAND_24_HT40_CHANNELS (2*0xA0) /* 14 bytes */
-
-/*
- * 5.2 GHz HT40 channels 36 (40), 44 (48), 52 (56), 60 (64),
- * 100 (104), 108 (112), 116 (120), 124 (128), 132 (136), 149 (153), 157 (161)
- */
-#define EEPROM_4965_REGULATORY_BAND_52_HT40_CHANNELS (2*0xA8) /* 22 bytes */
-
#define EEPROM_REGULATORY_BAND_NO_HT40 (0)
struct iwl_eeprom_ops {