diff options
| -rw-r--r-- | Documentation/devicetree/bindings/mtd/denali-nand.txt | 7 | ||||
| -rw-r--r-- | drivers/mtd/nand/denali.c | 87 | ||||
| -rw-r--r-- | drivers/mtd/nand/denali.h | 12 | ||||
| -rw-r--r-- | drivers/mtd/nand/denali_dt.c | 5 | ||||
| -rw-r--r-- | drivers/mtd/nand/denali_pci.c | 4 |
5 files changed, 78 insertions, 37 deletions
diff --git a/Documentation/devicetree/bindings/mtd/denali-nand.txt b/Documentation/devicetree/bindings/mtd/denali-nand.txt index e593bbeb2115..b7742a7363ea 100644 --- a/Documentation/devicetree/bindings/mtd/denali-nand.txt +++ b/Documentation/devicetree/bindings/mtd/denali-nand.txt @@ -7,6 +7,13 @@ Required properties: - reg-names: Should contain the reg names "nand_data" and "denali_reg" - interrupts : The interrupt number. +Optional properties: + - nand-ecc-step-size: see nand.txt for details. If present, the value must be + 512 for "altr,socfpga-denali-nand" + - nand-ecc-strength: see nand.txt for details. Valid values are: + 8, 15 for "altr,socfpga-denali-nand" + - nand-ecc-maximize: see nand.txt for details + The device tree may optionally contain sub-nodes describing partitions of the address space. See partition.txt for more detail. diff --git a/drivers/mtd/nand/denali.c b/drivers/mtd/nand/denali.c index b3c99d98fdee..2d3d9875dfaa 100644 --- a/drivers/mtd/nand/denali.c +++ b/drivers/mtd/nand/denali.c @@ -886,8 +886,6 @@ static int denali_hw_ecc_fixup(struct mtd_info *mtd, return max_bitflips; } -#define ECC_SECTOR_SIZE 512 - #define ECC_SECTOR(x) (((x) & ECC_ERROR_ADDRESS__SECTOR_NR) >> 12) #define ECC_BYTE(x) (((x) & ECC_ERROR_ADDRESS__OFFSET)) #define ECC_CORRECTION_VALUE(x) ((x) & ERR_CORRECTION_INFO__BYTEMASK) @@ -899,6 +897,7 @@ static int denali_sw_ecc_fixup(struct mtd_info *mtd, struct denali_nand_info *denali, unsigned long *uncor_ecc_flags, uint8_t *buf) { + unsigned int ecc_size = denali->nand.ecc.size; unsigned int bitflips = 0; unsigned int max_bitflips = 0; uint32_t err_addr, err_cor_info; @@ -928,9 +927,9 @@ static int denali_sw_ecc_fixup(struct mtd_info *mtd, * an erased sector. */ *uncor_ecc_flags |= BIT(err_sector); - } else if (err_byte < ECC_SECTOR_SIZE) { + } else if (err_byte < ecc_size) { /* - * If err_byte is larger than ECC_SECTOR_SIZE, means error + * If err_byte is larger than ecc_size, means error * happened in OOB, so we ignore it. It's no need for * us to correct it err_device is represented the NAND * error bits are happened in if there are more than @@ -939,7 +938,7 @@ static int denali_sw_ecc_fixup(struct mtd_info *mtd, int offset; unsigned int flips_in_byte; - offset = (err_sector * ECC_SECTOR_SIZE + err_byte) * + offset = (err_sector * ecc_size + err_byte) * denali->devnum + err_device; /* correct the ECC error */ @@ -1345,13 +1344,39 @@ static void denali_hw_init(struct denali_nand_info *denali) denali_irq_init(denali); } -/* - * Althogh controller spec said SLC ECC is forceb to be 4bit, - * but denali controller in MRST only support 15bit and 8bit ECC - * correction - */ -#define ECC_8BITS 14 -#define ECC_15BITS 26 +int denali_calc_ecc_bytes(int step_size, int strength) +{ + /* BCH code. Denali requires ecc.bytes to be multiple of 2 */ + return DIV_ROUND_UP(strength * fls(step_size * 8), 16) * 2; +} +EXPORT_SYMBOL(denali_calc_ecc_bytes); + +static int denali_ecc_setup(struct mtd_info *mtd, struct nand_chip *chip, + struct denali_nand_info *denali) +{ + int oobavail = mtd->oobsize - denali->bbtskipbytes; + int ret; + + /* + * If .size and .strength are already set (usually by DT), + * check if they are supported by this controller. + */ + if (chip->ecc.size && chip->ecc.strength) + return nand_check_ecc_caps(chip, denali->ecc_caps, oobavail); + + /* + * We want .size and .strength closest to the chip's requirement + * unless NAND_ECC_MAXIMIZE is requested. + */ + if (!(chip->ecc.options & NAND_ECC_MAXIMIZE)) { + ret = nand_match_ecc_req(chip, denali->ecc_caps, oobavail); + if (!ret) + return 0; + } + + /* Max ECC strength is the last thing we can do */ + return nand_maximize_ecc(chip, denali->ecc_caps, oobavail); +} static int denali_ooblayout_ecc(struct mtd_info *mtd, int section, struct mtd_oob_region *oobregion) @@ -1588,34 +1613,26 @@ int denali_init(struct denali_nand_info *denali) /* no subpage writes on denali */ chip->options |= NAND_NO_SUBPAGE_WRITE; - /* - * Denali Controller only support 15bit and 8bit ECC in MRST, - * so just let controller do 15bit ECC for MLC and 8bit ECC for - * SLC if possible. - * */ - if (!nand_is_slc(chip) && - (mtd->oobsize > (denali->bbtskipbytes + - ECC_15BITS * (mtd->writesize / - ECC_SECTOR_SIZE)))) { - /* if MLC OOB size is large enough, use 15bit ECC*/ - chip->ecc.strength = 15; - chip->ecc.bytes = ECC_15BITS; - iowrite32(15, denali->flash_reg + ECC_CORRECTION); - } else if (mtd->oobsize < (denali->bbtskipbytes + - ECC_8BITS * (mtd->writesize / - ECC_SECTOR_SIZE))) { - pr_err("Your NAND chip OOB is not large enough to contain 8bit ECC correction codes"); + ret = denali_ecc_setup(mtd, chip, denali); + if (ret) { + dev_err(denali->dev, "Failed to setup ECC settings.\n"); goto failed_req_irq; - } else { - chip->ecc.strength = 8; - chip->ecc.bytes = ECC_8BITS; - iowrite32(8, denali->flash_reg + ECC_CORRECTION); } + dev_dbg(denali->dev, + "chosen ECC settings: step=%d, strength=%d, bytes=%d\n", + chip->ecc.size, chip->ecc.strength, chip->ecc.bytes); + + iowrite32(chip->ecc.strength, denali->flash_reg + ECC_CORRECTION); + + iowrite32(chip->ecc.size, denali->flash_reg + CFG_DATA_BLOCK_SIZE); + iowrite32(chip->ecc.size, denali->flash_reg + CFG_LAST_DATA_BLOCK_SIZE); + /* chip->ecc.steps is set by nand_scan_tail(); not available here */ + iowrite32(mtd->writesize / chip->ecc.size, + denali->flash_reg + CFG_NUM_DATA_BLOCKS); + mtd_set_ooblayout(mtd, &denali_ooblayout_ops); - /* override the default read operations */ - chip->ecc.size = ECC_SECTOR_SIZE; chip->ecc.read_page = denali_read_page; chip->ecc.read_page_raw = denali_read_page_raw; chip->ecc.write_page = denali_write_page; diff --git a/drivers/mtd/nand/denali.h b/drivers/mtd/nand/denali.h index 37833535a7a3..a06ed741b550 100644 --- a/drivers/mtd/nand/denali.h +++ b/drivers/mtd/nand/denali.h @@ -259,6 +259,14 @@ #define ECC_COR_INFO__MAX_ERRORS GENMASK(6, 0) #define ECC_COR_INFO__UNCOR_ERR BIT(7) +#define CFG_DATA_BLOCK_SIZE 0x6b0 + +#define CFG_LAST_DATA_BLOCK_SIZE 0x6c0 + +#define CFG_NUM_DATA_BLOCKS 0x6d0 + +#define CFG_META_DATA_SIZE 0x6e0 + #define DMA_ENABLE 0x700 #define DMA_ENABLE__FLAG BIT(0) @@ -301,8 +309,6 @@ #define MODE_10 0x08000000 #define MODE_11 0x0C000000 -#define ECC_SECTOR_SIZE 512 - struct nand_buf { int head; int tail; @@ -337,11 +343,13 @@ struct denali_nand_info { int max_banks; unsigned int revision; unsigned int caps; + const struct nand_ecc_caps *ecc_caps; }; #define DENALI_CAP_HW_ECC_FIXUP BIT(0) #define DENALI_CAP_DMA_64BIT BIT(1) +int denali_calc_ecc_bytes(int step_size, int strength); extern int denali_init(struct denali_nand_info *denali); extern void denali_remove(struct denali_nand_info *denali); diff --git a/drivers/mtd/nand/denali_dt.c b/drivers/mtd/nand/denali_dt.c index b48430fe3cd4..bd1aa4cf4457 100644 --- a/drivers/mtd/nand/denali_dt.c +++ b/drivers/mtd/nand/denali_dt.c @@ -32,10 +32,14 @@ struct denali_dt { struct denali_dt_data { unsigned int revision; unsigned int caps; + const struct nand_ecc_caps *ecc_caps; }; +NAND_ECC_CAPS_SINGLE(denali_socfpga_ecc_caps, denali_calc_ecc_bytes, + 512, 8, 15); static const struct denali_dt_data denali_socfpga_data = { .caps = DENALI_CAP_HW_ECC_FIXUP, + .ecc_caps = &denali_socfpga_ecc_caps, }; static const struct of_device_id denali_nand_dt_ids[] = { @@ -64,6 +68,7 @@ static int denali_dt_probe(struct platform_device *pdev) if (data) { denali->revision = data->revision; denali->caps = data->caps; + denali->ecc_caps = data->ecc_caps; } denali->platform = DT; diff --git a/drivers/mtd/nand/denali_pci.c b/drivers/mtd/nand/denali_pci.c index ac843238b77e..37dc0934c24c 100644 --- a/drivers/mtd/nand/denali_pci.c +++ b/drivers/mtd/nand/denali_pci.c @@ -27,6 +27,8 @@ static const struct pci_device_id denali_pci_ids[] = { }; MODULE_DEVICE_TABLE(pci, denali_pci_ids); +NAND_ECC_CAPS_SINGLE(denali_pci_ecc_caps, denali_calc_ecc_bytes, 512, 8, 15); + static int denali_pci_probe(struct pci_dev *dev, const struct pci_device_id *id) { int ret; @@ -65,6 +67,8 @@ static int denali_pci_probe(struct pci_dev *dev, const struct pci_device_id *id) pci_set_master(dev); denali->dev = &dev->dev; denali->irq = dev->irq; + denali->ecc_caps = &denali_pci_ecc_caps; + denali->nand.ecc.options |= NAND_ECC_MAXIMIZE; ret = pci_request_regions(dev, DENALI_NAND_NAME); if (ret) { |