diff options
Diffstat (limited to 'arch/arm/mach-omap2/board-devkit8000.c')
-rw-r--r-- | arch/arm/mach-omap2/board-devkit8000.c | 105 |
1 files changed, 58 insertions, 47 deletions
diff --git a/arch/arm/mach-omap2/board-devkit8000.c b/arch/arm/mach-omap2/board-devkit8000.c index 53ac762518bd..aa27483c493e 100644 --- a/arch/arm/mach-omap2/board-devkit8000.c +++ b/arch/arm/mach-omap2/board-devkit8000.c @@ -46,6 +46,7 @@ #include <plat/nand.h> #include <plat/usb.h> #include <plat/display.h> +#include <plat/panel-generic-dpi.h> #include <plat/mcspi.h> #include <linux/input/matrix_keypad.h> @@ -114,58 +115,64 @@ static struct omap2_hsmmc_info mmc[] = { static int devkit8000_panel_enable_lcd(struct omap_dss_device *dssdev) { - twl_i2c_write_u8(TWL4030_MODULE_GPIO, 0x80, REG_GPIODATADIR1); - twl_i2c_write_u8(TWL4030_MODULE_LED, 0x0, 0x0); - if (gpio_is_valid(dssdev->reset_gpio)) - gpio_set_value(dssdev->reset_gpio, 1); + gpio_set_value_cansleep(dssdev->reset_gpio, 1); return 0; } static void devkit8000_panel_disable_lcd(struct omap_dss_device *dssdev) { if (gpio_is_valid(dssdev->reset_gpio)) - gpio_set_value(dssdev->reset_gpio, 0); + gpio_set_value_cansleep(dssdev->reset_gpio, 0); } static int devkit8000_panel_enable_dvi(struct omap_dss_device *dssdev) { if (gpio_is_valid(dssdev->reset_gpio)) - gpio_set_value(dssdev->reset_gpio, 1); + gpio_set_value_cansleep(dssdev->reset_gpio, 1); return 0; } static void devkit8000_panel_disable_dvi(struct omap_dss_device *dssdev) { if (gpio_is_valid(dssdev->reset_gpio)) - gpio_set_value(dssdev->reset_gpio, 0); + gpio_set_value_cansleep(dssdev->reset_gpio, 0); } static struct regulator_consumer_supply devkit8000_vmmc1_supply = - REGULATOR_SUPPLY("vmmc", "mmci-omap-hs.0"); + REGULATOR_SUPPLY("vmmc", "omap_hsmmc.0"); /* ads7846 on SPI */ static struct regulator_consumer_supply devkit8000_vio_supply = REGULATOR_SUPPLY("vcc", "spi2.0"); +static struct panel_generic_dpi_data lcd_panel = { + .name = "generic", + .platform_enable = devkit8000_panel_enable_lcd, + .platform_disable = devkit8000_panel_disable_lcd, +}; + static struct omap_dss_device devkit8000_lcd_device = { .name = "lcd", - .driver_name = "generic_panel", .type = OMAP_DISPLAY_TYPE_DPI, + .driver_name = "generic_dpi_panel", + .data = &lcd_panel, .phy.dpi.data_lines = 24, - .reset_gpio = -EINVAL, /* will be replaced */ - .platform_enable = devkit8000_panel_enable_lcd, - .platform_disable = devkit8000_panel_disable_lcd, }; + +static struct panel_generic_dpi_data dvi_panel = { + .name = "generic", + .platform_enable = devkit8000_panel_enable_dvi, + .platform_disable = devkit8000_panel_disable_dvi, +}; + static struct omap_dss_device devkit8000_dvi_device = { .name = "dvi", - .driver_name = "generic_panel", .type = OMAP_DISPLAY_TYPE_DPI, + .driver_name = "generic_dpi_panel", + .data = &dvi_panel, .phy.dpi.data_lines = 24, - .reset_gpio = -EINVAL, /* will be replaced */ - .platform_enable = devkit8000_panel_enable_dvi, - .platform_disable = devkit8000_panel_disable_dvi, }; static struct omap_dss_device devkit8000_tv_device = { @@ -188,14 +195,6 @@ static struct omap_dss_board_info devkit8000_dss_data = { .default_device = &devkit8000_lcd_device, }; -static struct platform_device devkit8000_dss_device = { - .name = "omapdss", - .id = -1, - .dev = { - .platform_data = &devkit8000_dss_data, - }, -}; - static struct regulator_consumer_supply devkit8000_vdda_dac_supply = REGULATOR_SUPPLY("vdda_dac", "omapdss"); @@ -237,6 +236,8 @@ static struct gpio_led gpio_leds[]; static int devkit8000_twl_gpio_setup(struct device *dev, unsigned gpio, unsigned ngpio) { + int ret; + omap_mux_init_gpio(29, OMAP_PIN_INPUT); /* gpio + 0 is "mmc0_cd" (input/IRQ) */ mmc[0].gpio_cd = gpio + 0; @@ -245,17 +246,23 @@ static int devkit8000_twl_gpio_setup(struct device *dev, /* TWL4030_GPIO_MAX + 1 == ledB, PMU_STAT (out, active low LED) */ gpio_leds[2].gpio = gpio + TWL4030_GPIO_MAX + 1; - /* gpio + 1 is "LCD_PWREN" (out, active high) */ - devkit8000_lcd_device.reset_gpio = gpio + 1; - gpio_request(devkit8000_lcd_device.reset_gpio, "LCD_PWREN"); - /* Disable until needed */ - gpio_direction_output(devkit8000_lcd_device.reset_gpio, 0); + /* TWL4030_GPIO_MAX + 0 is "LCD_PWREN" (out, active high) */ + devkit8000_lcd_device.reset_gpio = gpio + TWL4030_GPIO_MAX + 0; + ret = gpio_request_one(devkit8000_lcd_device.reset_gpio, + GPIOF_DIR_OUT | GPIOF_INIT_LOW, "LCD_PWREN"); + if (ret < 0) { + devkit8000_lcd_device.reset_gpio = -EINVAL; + printk(KERN_ERR "Failed to request GPIO for LCD_PWRN\n"); + } /* gpio + 7 is "DVI_PD" (out, active low) */ devkit8000_dvi_device.reset_gpio = gpio + 7; - gpio_request(devkit8000_dvi_device.reset_gpio, "DVI PowerDown"); - /* Disable until needed */ - gpio_direction_output(devkit8000_dvi_device.reset_gpio, 0); + ret = gpio_request_one(devkit8000_dvi_device.reset_gpio, + GPIOF_DIR_OUT | GPIOF_INIT_LOW, "DVI PowerDown"); + if (ret < 0) { + devkit8000_dvi_device.reset_gpio = -EINVAL; + printk(KERN_ERR "Failed to request GPIO for DVI PowerDown\n"); + } return 0; } @@ -265,8 +272,7 @@ static struct twl4030_gpio_platform_data devkit8000_gpio_data = { .irq_base = TWL4030_GPIO_IRQ_BASE, .irq_end = TWL4030_GPIO_IRQ_END, .use_leds = true, - .pullups = BIT(1), - .pulldowns = BIT(2) | BIT(6) | BIT(7) | BIT(8) | BIT(13) + .pulldowns = BIT(1) | BIT(2) | BIT(6) | BIT(8) | BIT(13) | BIT(15) | BIT(16) | BIT(17), .setup = devkit8000_twl_gpio_setup, }; @@ -336,9 +342,7 @@ static struct twl4030_usb_data devkit8000_usb_data = { .usb_mode = T2_USB_MODE_ULPI, }; -static struct twl4030_codec_audio_data devkit8000_audio_data = { - .audio_mclk = 26000000, -}; +static struct twl4030_codec_audio_data devkit8000_audio_data; static struct twl4030_codec_data devkit8000_codec_data = { .audio_mclk = 26000000, @@ -442,15 +446,19 @@ static struct platform_device keys_gpio = { }; +static void __init devkit8000_init_early(void) +{ + omap2_init_common_infrastructure(); + omap2_init_common_devices(mt46h32m32lf6_sdrc_params, + mt46h32m32lf6_sdrc_params); +} + static void __init devkit8000_init_irq(void) { - omap2_init_common_hw(mt46h32m32lf6_sdrc_params, - mt46h32m32lf6_sdrc_params); omap_init_irq(); #ifdef CONFIG_OMAP_32K_TIMER omap2_gp_clockevent_set_gptimer(12); #endif - omap_gpio_init(); } static void __init devkit8000_ads7846_init(void) @@ -561,7 +569,6 @@ static void __init omap_dm9000_init(void) } static struct platform_device *devkit8000_devices[] __initdata = { - &devkit8000_dss_device, &leds_gpio, &keys_gpio, &omap_dm9000_dev, @@ -606,11 +613,11 @@ static struct omap_musb_board_data musb_board_data = { .power = 100, }; -static const struct ehci_hcd_omap_platform_data ehci_pdata __initconst = { +static const struct usbhs_omap_board_data usbhs_bdata __initconst = { - .port_mode[0] = EHCI_HCD_OMAP_MODE_PHY, - .port_mode[1] = EHCI_HCD_OMAP_MODE_UNKNOWN, - .port_mode[2] = EHCI_HCD_OMAP_MODE_UNKNOWN, + .port_mode[0] = OMAP_EHCI_PORT_MODE_PHY, + .port_mode[1] = OMAP_USBHS_PORT_MODE_UNUSED, + .port_mode[2] = OMAP_USBHS_PORT_MODE_UNUSED, .phy_reset = true, .reset_gpio_port[0] = -EINVAL, @@ -618,6 +625,7 @@ static const struct ehci_hcd_omap_platform_data ehci_pdata __initconst = { .reset_gpio_port[2] = -EINVAL }; +#ifdef CONFIG_OMAP_MUX static struct omap_board_mux board_mux[] __initdata = { /* nCS and IRQ for Devkit8000 ethernet */ OMAP3_MUX(GPMC_NCS6, OMAP_MUX_MODE0), @@ -771,6 +779,7 @@ static struct omap_board_mux board_mux[] __initdata = { { .reg_offset = OMAP_MUX_TERMINATOR }, }; +#endif static void __init devkit8000_init(void) { @@ -783,13 +792,14 @@ static void __init devkit8000_init(void) platform_add_devices(devkit8000_devices, ARRAY_SIZE(devkit8000_devices)); + omap_display_init(&devkit8000_dss_data); spi_register_board_info(devkit8000_spi_board_info, ARRAY_SIZE(devkit8000_spi_board_info)); devkit8000_ads7846_init(); usb_musb_init(&musb_board_data); - usb_ehci_init(&ehci_pdata); + usbhs_init(&usbhs_bdata); devkit8000_flash_init(); /* Ensure SDRC pins are mux'd for self-refresh */ @@ -799,8 +809,9 @@ static void __init devkit8000_init(void) MACHINE_START(DEVKIT8000, "OMAP3 Devkit8000") .boot_params = 0x80000100, - .map_io = omap3_map_io, .reserve = omap_reserve, + .map_io = omap3_map_io, + .init_early = devkit8000_init_early, .init_irq = devkit8000_init_irq, .init_machine = devkit8000_init, .timer = &omap_timer, |