diff options
Diffstat (limited to 'drivers/misc/Kconfig')
| -rw-r--r-- | drivers/misc/Kconfig | 41 |
1 files changed, 39 insertions, 2 deletions
diff --git a/drivers/misc/Kconfig b/drivers/misc/Kconfig index 5664696f2d3a..951ae6c75011 100644 --- a/drivers/misc/Kconfig +++ b/drivers/misc/Kconfig @@ -82,6 +82,7 @@ config AB8500_PWM config ATMEL_TCLIB bool "Atmel AT32/AT91 Timer/Counter Library" depends on (AVR32 || ARCH_AT91) + default y if PREEMPT_RT_FULL help Select this if you want a library to allocate the Timer/Counter blocks found on many Atmel processors. This facilitates using @@ -97,8 +98,7 @@ config ATMEL_TCB_CLKSRC are combined to make a single 32-bit timer. When GENERIC_CLOCKEVENTS is defined, the third timer channel - may be used as a clock event device supporting oneshot mode - (delays of up to two seconds) based on the 32 KiHz clock. + may be used as a clock event device supporting oneshot mode. config ATMEL_TCB_CLKSRC_BLOCK int @@ -112,6 +112,14 @@ config ATMEL_TCB_CLKSRC_BLOCK TC can be used for other purposes, such as PWM generation and interval timing. +config ATMEL_TCB_CLKSRC_USE_SLOW_CLOCK + bool "TC Block use 32 KiHz clock" + depends on ATMEL_TCB_CLKSRC + default y if !PREEMPT_RT_FULL + help + Select this to use 32 KiHz base clock rate as TC block clock + source for clock events. + config IBM_ASM tristate "Device driver for IBM RSA service processor" depends on X86 && PCI && INPUT && EXPERIMENTAL @@ -133,6 +141,35 @@ config IBM_ASM for information on the specific driver level and support statement for your IBM server. +config HWLAT_DETECTOR + tristate "Testing module to detect hardware-induced latencies" + depends on DEBUG_FS + depends on RING_BUFFER + default m + ---help--- + A simple hardware latency detector. Use this module to detect + large latencies introduced by the behavior of the underlying + system firmware external to Linux. We do this using periodic + use of stop_machine to grab all available CPUs and measure + for unexplainable gaps in the CPU timestamp counter(s). By + default, the module is not enabled until the "enable" file + within the "hwlat_detector" debugfs directory is toggled. + + This module is often used to detect SMI (System Management + Interrupts) on x86 systems, though is not x86 specific. To + this end, we default to using a sample window of 1 second, + during which we will sample for 0.5 seconds. If an SMI or + similar event occurs during that time, it is recorded + into an 8K samples global ring buffer until retreived. + + WARNING: This software should never be enabled (it can be built + but should not be turned on after it is loaded) in a production + environment where high latencies are a concern since the + sampling mechanism actually introduces latencies for + regular tasks while the CPU(s) are being held. + + If unsure, say N + config PHANTOM tristate "Sensable PHANToM (PCI)" depends on PCI |