summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2013-11-07da9063: phyflex-i.MX6: Add default LDO bypass modeChristian Hemp
2013-11-07Fixed registration of tw9910 capture board on csi interfaces.Andrei Andreyanau
2013-11-07Fixed i2c_board_info's typoAndrei Andreyanau
2013-11-07board-mx6q_phyflex: New bootargs addedDirk Bender
2013-11-07mt9p031: Changed the possible PLL stettingsDirk Bender
2013-11-07Added support for faster frame rate for small resolutions for mt9m111 (VM-009...Andrei Andreyanau
2013-11-07Fixed drive strength field for clko. Added drive strength field setting for c...Andrei Andreyanau
2013-11-07Fixed support for mt9v022 (VM-007/VM-010) camera.Andrei Andreyanau
2013-11-07Fixed support for clko2_clk output pinAndrei Andreyanau
2013-11-07Added support for clocking the camera, connected to csi2 interface. Fixed clk...Andrei Andreyanau
2013-11-07Fix TODO records.Grigory Milev
2013-11-07Modify da9063 i2c driver. Added capability wakeup from da9063 irq (in particu...Anatoly Palto
2013-11-07Fix mistake in da9063 driver to work onkeyeventsAnatoly Palto
2013-11-07Removed 12 bit support from host camera driverAndrei Andreyanau
2013-11-07Added new divider for 54MHz MCLK for mt9p031 camera. Also, recalculated divid...Andrei Andreyanau
2013-11-07Fixed bayer sync for mt9p031 camera driverAndrei Andreyanau
2013-11-07Set hblank to calculate values to get optimal fps for different resolutions.Andrei Andreyanau
2013-11-07Fixed top/left position calculation for mt9p031 camera driverAndrei Andreyanau
2013-11-07Cosmetic changes to tw9910 driver.Dmitry Lavnikevich
2013-11-07Implemented support for m24c04 eeprom on video capture board (VM-008).Dmitry Lavnikevich
2013-11-07Implemented video capture board led control.Dmitry Lavnikevich
2013-11-07Enabled deinterlacing for interlaced sensors.Dmitry Lavnikevich
2013-11-07Added support for specific setting for different resolutions for MT9P031 came...Andrei Andreyanau
2013-11-07Added support for switching on/off internal pll for MT9P031 camera. Also adde...Andrei Andreyanau
2013-11-07Added base implementation of tw9910.Dmitry Lavnikevich
2013-11-07Code optimization for calculation of correct binning/skipping values for mt9p...Andrei Andreyanau
2013-11-07fec: tune RSEM and RSFL values for tapeout 1.0Eric Nelson
2013-11-07fec: enable tx/rx of pause frames for mx6qTroy Kisky
2013-11-07fec: fix rx error countsTroy Kisky
2013-11-07fec: stop the "rcv is not +last, " error messagesTroy Kisky
2013-11-07phyFLEX-i.MX6: Set pice reset gpioChristian Hemp
2013-11-07phyFLEX-imx6: Set SD3 WP to correct gpioChristian Hemp
2013-11-07phyflex-i.MX6: Mux GPIO 0 for usb1 enableChristian Hemp
2013-11-07phyFLEX-i.MX6: Set pice reset gpioChristian Hemp
2013-11-07phyFLEX-i.MX6: Added new GPIOsChristian Hemp
2013-11-07phyFLEX-i.MX6: Remove PEB codeChristian Hemp
2013-11-07phyFLEX-i.MX6: remove spi nor partionsChristian Hemp
2013-11-07phyflex-iMX6: Remove phyflex fixupChristian Hemp
2013-11-07phyflex-imx6: Remove NAND partition defenition from codeChristian Hemp
2013-11-07mt9m001: Fix the testpattern bit overwritten.Christian Hemp
2013-11-07phyflex: only use second ldb fb if hdmi is not usedDaniel Mierswa
2013-11-07phyflex: introduce pin define for hw introspectionDaniel Mierswa
2013-11-07imx6 power offChristian Hemp
2013-11-07phyflex-imx6: add selection for phyCAM-P and S+Christian Hemp
2013-11-07Add Display ETM0700G0DH6Christian Hemp
2013-11-07phyflex-imx6: Added etd touch driver to platfomChristian Hemp
2013-11-07EDT-FT5x06: named the requested gpiosEnrico Scholz
2013-11-07EDT-FT5x06: allow unconfigured reset gpioEnrico Scholz
2013-11-07EDT-FT5x06: kernel 3.0 adaptationsEnrico Scholz
2013-11-07EDT-FT5x06: initial checkin of upstream FT5x06 patchEnrico Scholz
generated by cgit v1.2.3 (git 2.0.4) at 2024-05-02 15:49:50 +0000