summaryrefslogtreecommitdiff
path: root/arch/arm
AgeCommit message (Expand)Author
2010-12-24ENGR00137362-1 L2Switch: Add ENET-MAC interrupt resourceXie Xiaobo
2010-12-17ENGR00137101-1 clock : keep GPMI and BCH working in the same frequencyHuang Shijie
2010-12-16ENGR00136909: MX50: Drop DDR freq to 133Mhz when AHB is at medium setpoint.Ranjani Vaidyanathan
2010-12-15ENGR00136939-2: MX50: Fix suspend/resume issue on MX50 RDPRanjani Vaidyanathan
2010-12-15ENGR00136990-2 MX50: Add sys interface to control ZQ calib run intervalRobby Cai
2010-12-15ENGR00136990-1 MX50: fix system resume failure issue due to ZQ calibrationRobby Cai
2010-12-13ENGR00136875-1 Add function pgprot_writethru()Robby Cai
2010-12-10ENGR00136231: Read MAC ID from the IIM fuses for SMSC911x driverDinh Nguyen
2010-12-10ENGR00136190: MX50 RD1: Incorrect IOMUX settings break WVGA displayRanjani Vaidyanathan
2010-12-10ENGR00136219 MX28: Fix keypad can't wake up systemFrank Li
2010-12-10ENGR00136202 MX50: Finetune DLL delay paramater for LPDDR2Robby Cai
2010-12-10ENGR00136195 MX28-MSL: fix AHB clock divider issuePeter Chen
2010-12-09ENGR00136170 MX50: Add ZQ calibration revision for TO1.1Robby Cai
2010-12-08ENGR00136146-1 MX53 TO2 ARD: Change VDDGP and VCC valuesNancy Chen
2010-12-08ENGR00136097-2 mx50 rdp: add support to addon board's power key eventXinyu Chen
2010-12-06ENGR00136022: MXC:Fixed bugs in bus_frequency driver.Ranjani Vaidyanathan
2010-12-06ENGR00136004 iMX28: set NO_HZ and preempt as default configFrank Li
2010-12-06ENGR00134193-2 MX28: Fix FEC can't found phy after fix timer issueFrank Li
2010-12-06ENGR00134193-1 TIMER: Fix i.MX28 set wrong match value of timerFrank Li
2010-12-04ENGR00135048-2: MX50: Added support for bus-frequency scaling.Ranjani Vaidyanathan
2010-12-04ENGR00135048-1: Fixed bugs in common sw bus frequency scaling code.Ranjani Vaidyanathan
2010-12-03ENGR000135959: MX50: Relock PLL1 to 160MHz in LPAPM mode.Ranjani Vaidyanathan
2010-12-03ENGR00134277 MX50: turn off the ZQ calibration configRobby Cai
2010-12-03ENGR00133052 MX53: Fix system hang in vpu decoding with iram.Sammy He
2010-12-03ENGR00134041 [MX53] Add the SATA AHCI temperature monitorRichard Zhu
2010-12-02ENGR00133860 - MSL: EPDC data pin GPIO numbers off by 1Danny Nold
2010-12-02ENGR00134154-2 MSL: add sync between usb resume and usb wakeup thread for MX5xPeter Chen
2010-12-02ENGR00134154-1 MSL: add sync between usb resume and usb wakeup thread for mx28Peter Chen
2010-12-01ENGR00133828-2: MX50 EVK: Fix FEC GPIO/IOMUX settings in suspend mode.Ranjani Vaidyanathan
2010-12-01ENGR00133828-1: MX50 EVK: Shutting down VUSB2 in suspend causes USB failuresRanjani Vaidyanathan
2010-12-01ENGR00134202-1 DMA : add a macro to fill the DMA command word1Huang Shijie
2010-12-01ENGR00134179 mx50 rdp: set VSD regulator always onAisheng.Dong
2010-12-01ENGR00133542: MX50- Enable SRPG support for TO1.1 chipsZhou Jingyu
2010-11-30ENGR00134077-1 Add TVE 1080P30/25/24, 1080I60/50 support for iMX53Ran Ferderber
2010-11-30ENGR00134043-2 PM:enable device suspend time mx3/5Zhang Jiejing
2010-11-29ENGR00134116 MX5 MFG: disable battery driverLily Zhang
2010-11-29ENGR00132603-1 mxc_iim: Add mach support for sense and fuse function in mxc_iimTerry Lv
2010-11-25ENGR00134056-1 MSL: mx28 add low power mode and wakeup support for otg portPeter Chen
2010-11-24ENGR00133954-1 MSL: remove FB_SYNC_EXT flagJason Chen
2010-11-24ENGR00133970 MX5x: Z160 GPU revision checkJie Zhou
2010-11-24ENGR00133918 mx50: ZQ calibration should be run only on mx50 platformTerry Lv
2010-11-23ENGR00133955 MX50: dma apbh incorrect ioremap sizeXinyu Chen
2010-11-23ENGR00133909-1 MX28: add VBUS 5v regulatorZhou Jingyu
2010-11-22ENGR00133240 MX50 TO1 mDDR at 24 MHz in LPAPM modeAnish Trivedi
2010-11-22ENGR00133906-1 DMA : add dumping code for DMAHuang Shijie
2010-11-22ENGR00133848 imx51 MSL uart: change uart default parent to pll2Jason Chen
2010-11-22ENGR00133905 MX53 ARD: increase VDDGP and VCC voltages in suspend modeLily Zhang
2010-11-22ENGR00133862: Mx50: Drop Vcc voltage to 1.05V in LPAPM modeRanjani Vaidyanathan
2010-11-22ENGR00132712-2 Add ZQ calib in defconfigRobby Cai
2010-11-22ENGR00132712-1: Add ZQ calibration supportRobby Cai
generated by cgit v1.2.3 (git 2.0.4) at 2024-04-23 20:06:31 +0000