menuconfig TRDX_CFG_BLOCK
	bool "Enable Toradex config block support"
	help
	  The Toradex config block stored production data on the on-module
	  flash device (NAND or eMMC). The area is normally preserved by
	  software and contains the serial number (out of which the MAC
	  address is generated) and the exact module type.

# Helper config to determine the correct default location of the cfg block
config TRDX_HAVE_NAND
	bool

config TRDX_HAVE_MMC
	bool

if TRDX_CFG_BLOCK

choice
	prompt "Toradex config block location"
	depends on TRDX_CFG_BLOCK
	default TRDX_CFG_BLOCK_IS_IN_NAND if TRDX_HAVE_NAND
	default TRDX_CFG_BLOCK_IS_IN_MMC if TRDX_HAVE_MMC
	help
	  Configure the location of the Toradex config block. By default, the
	  factory version of the Toradex config block is on the NAND or eMMC
	  flash device on the module.

config TRDX_CFG_BLOCK_IS_IN_NAND
	bool "Location of the config block is in NAND"

config TRDX_CFG_BLOCK_IS_IN_MMC
	bool "Location of the config block is in eMMC"

endchoice

config TRDX_CFG_BLOCK_DEV
	int "Toradex config block eMMC device ID"
	depends on TRDX_CFG_BLOCK_IS_IN_MMC

config TRDX_CFG_BLOCK_PART
	int "Toradex config block eMMC partition ID"
	depends on TRDX_CFG_BLOCK_IS_IN_MMC

config TRDX_CFG_BLOCK_OFFSET
	int "Toradex config block offset"
	help
	  Specify the byte offset of the Toradex config block within the flash
	  device the config block is stored on.

config TRDX_CFG_BLOCK_2ND_ETHADDR
	bool "Set the second ethernet address"
	help
	  For each serial number two Ethernet addresses are available for dual
	  Ethernet carrier boards. This options enables the code to set the
	  second ethernet address as environment variable (eth1addr).

endif