diff options
| author | Stephen Boyd <stephen.boyd@linaro.org> | 2017-01-26 16:47:26 -0800 |
|---|---|---|
| committer | Andy Gross <andy.gross@linaro.org> | 2017-05-26 00:40:58 -0500 |
| commit | 4ac5a200b06f1522f8bcc7df1e45ee17221d166a (patch) | |
| tree | 699a9d414b6f817e326d083249a4fbfc858d2185 /arch/arm/boot/dts/qcom-pm8941.dtsi | |
| parent | ffb35d431b7666544994ecef0ef8b2227c20b6da (diff) | |
ARM: dts: qcom-msm8974: Add HS usb node and OTG detection mechanisms
This USB controller has two phys, so add them both underneath the
ULPI bus, but only enable one of them based on the board
configuration. To get OTG to work, we need to add the id and vbus
detection info and also populate the regulators for the vbus
supply.
Signed-off-by: Stephen Boyd <stephen.boyd@linaro.org>
Signed-off-by: Andy Gross <andy.gross@linaro.org>
Diffstat (limited to 'arch/arm/boot/dts/qcom-pm8941.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/qcom-pm8941.dtsi | 32 |
1 files changed, 31 insertions, 1 deletions
diff --git a/arch/arm/boot/dts/qcom-pm8941.dtsi b/arch/arm/boot/dts/qcom-pm8941.dtsi index 6b16b296f0fa..3fc9f34f45bb 100644 --- a/arch/arm/boot/dts/qcom-pm8941.dtsi +++ b/arch/arm/boot/dts/qcom-pm8941.dtsi @@ -26,7 +26,14 @@ bias-pull-up; }; - charger@1000 { + usb_id: misc@900 { + compatible = "qcom,pm8941-misc"; + reg = <0x900>; + interrupts = <0x0 0x9 0 IRQ_TYPE_EDGE_BOTH>; + interrupt-names = "usb_id"; + }; + + smbb: charger@1000 { compatible = "qcom,pm8941-charger"; reg = <0x1000>; interrupts = <0x0 0x10 7 IRQ_TYPE_EDGE_BOTH>, @@ -175,5 +182,28 @@ status = "disabled"; }; + + regulators { + compatible = "qcom,pm8941-regulators"; + interrupts = <0x1 0x83 0x2 0>, <0x1 0x84 0x2 0>; + interrupt-names = "ocp-5vs1", "ocp-5vs2"; + vin_5vs-supply = <&pm8941_5v>; + + pm8941_5v: s4 { + regulator-min-microvolt = <5000000>; + regulator-max-microvolt = <5000000>; + regulator-enable-ramp-delay = <500>; + }; + + pm8941_5vs1: 5vs1 { + regulator-enable-ramp-delay = <1000>; + regulator-pull-down; + regulator-over-current-protection; + qcom,ocp-max-retries = <10>; + qcom,ocp-retry-delay = <30>; + qcom,vs-soft-start-strength = <0>; + regulator-initial-mode = <1>; + }; + }; }; }; |