summaryrefslogtreecommitdiff
path: root/Documentation/devicetree/bindings/arm/omap/crossbar.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/arm/omap/crossbar.txt')
-rw-r--r--Documentation/devicetree/bindings/arm/omap/crossbar.txt36
1 files changed, 36 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/arm/omap/crossbar.txt b/Documentation/devicetree/bindings/arm/omap/crossbar.txt
index fb88585cfb93..4139db353d0a 100644
--- a/Documentation/devicetree/bindings/arm/omap/crossbar.txt
+++ b/Documentation/devicetree/bindings/arm/omap/crossbar.txt
@@ -10,6 +10,7 @@ Required properties:
- compatible : Should be "ti,irq-crossbar"
- reg: Base address and the size of the crossbar registers.
- ti,max-irqs: Total number of irqs available at the interrupt controller.
+- ti,max-crossbar-sources: Maximum number of crossbar sources that can be routed.
- ti,reg-size: Size of a individual register in bytes. Every individual
register is assumed to be of same size. Valid sizes are 1, 2, 4.
- ti,irqs-reserved: List of the reserved irq lines that are not muxed using
@@ -17,11 +18,46 @@ Required properties:
so crossbar bar driver should not consider them as free
lines.
+Optional properties:
+- ti,irqs-skip: This is similar to "ti,irqs-reserved", but these are for
+ SOC-specific hard-wiring of those irqs which unexpectedly bypasses the
+ crossbar. These irqs have a crossbar register, but still cannot be used.
+
+- ti,irqs-safe-map: integer which maps to a safe configuration to use
+ when the interrupt controller irq is unused (when not provided, default is 0)
+
Examples:
crossbar_mpu: @4a020000 {
compatible = "ti,irq-crossbar";
reg = <0x4a002a48 0x130>;
ti,max-irqs = <160>;
+ ti,max-crossbar-sources = <400>;
ti,reg-size = <2>;
ti,irqs-reserved = <0 1 2 3 5 6 131 132 139 140>;
+ ti,irqs-skip = <10 133 139 140>;
};
+
+Consumer:
+========
+See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt and
+Documentation/devicetree/bindings/arm/gic.txt for further details.
+
+An interrupt consumer on an SoC using crossbar will use:
+ interrupts = <GIC_SPI request_number interrupt_level>
+When the request number is between 0 to that described by
+"ti,max-crossbar-sources", it is assumed to be a crossbar mapping. If the
+request_number is greater than "ti,max-crossbar-sources", then it is mapped as a
+quirky hardware mapping direct to GIC.
+
+Example:
+ device_x@0x4a023000 {
+ /* Crossbar 8 used */
+ interrupts = <GIC_SPI 8 IRQ_TYPE_LEVEL_HIGH>;
+ ...
+ };
+
+ device_y@0x4a033000 {
+ /* Direct mapped GIC SPI 1 used */
+ interrupts = <GIC_SPI DIRECT_IRQ(1) IRQ_TYPE_LEVEL_HIGH>;
+ ...
+ };