summaryrefslogtreecommitdiff
path: root/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt')
-rw-r--r--Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt12
1 files changed, 3 insertions, 9 deletions
diff --git a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt
index bae1f2187226..44a9bb15dd56 100644
--- a/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt
+++ b/Documentation/devicetree/bindings/interrupt-controller/brcm,bcm7120-l2-intc.txt
@@ -13,8 +13,7 @@ Such an interrupt controller has the following hardware design:
or if they will output an interrupt signal at this 2nd level interrupt
controller, in particular for UARTs
-- typically has one 32-bit enable word and one 32-bit status word, but on
- some hardware may have more than one enable/status pair
+- has one 32-bit enable word and one 32-bit status word
- no atomic set/clear operations
@@ -53,9 +52,7 @@ The typical hardware layout for this controller is represented below:
Required properties:
- compatible: should be "brcm,bcm7120-l2-intc"
-- reg: specifies the base physical address and size of the registers;
- multiple pairs may be specified, with the first pair handling IRQ offsets
- 0..31 and the second pair handling 32..63
+- reg: specifies the base physical address and size of the registers
- interrupt-controller: identifies the node as an interrupt controller
- #interrupt-cells: specifies the number of cells needed to encode an interrupt
source, should be 1.
@@ -66,10 +63,7 @@ Required properties:
- brcm,int-map-mask: 32-bits bit mask describing how many and which interrupts
are wired to this 2nd level interrupt controller, and how they match their
respective interrupt parents. Should match exactly the number of interrupts
- specified in the 'interrupts' property, multiplied by the number of
- enable/status register pairs implemented by this controller. For
- multiple parent IRQs with multiple enable/status words, this looks like:
- <irq0_w0 irq0_w1 irq1_w0 irq1_w1 ...>
+ specified in the 'interrupts' property.
Optional properties: