diff options
Diffstat (limited to 'Documentation/kernel-parameters.txt')
| -rw-r--r-- | Documentation/kernel-parameters.txt | 22 |
1 files changed, 12 insertions, 10 deletions
diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt index f3dc951e949f..b72e071a3e5b 100644 --- a/Documentation/kernel-parameters.txt +++ b/Documentation/kernel-parameters.txt @@ -199,11 +199,6 @@ and is between 256 and 4096 characters. It is defined in the file unusable. The "log_buf_len" parameter may be useful if you need to capture more output. - acpi_display_output= [HW,ACPI] - acpi_display_output=vendor - acpi_display_output=video - See above. - acpi_irq_balance [HW,ACPI] ACPI will balance active IRQs default in APIC mode @@ -403,6 +398,10 @@ and is between 256 and 4096 characters. It is defined in the file bttv.pll= See Documentation/video4linux/bttv/Insmod-options bttv.tuner= and Documentation/video4linux/bttv/CARDLIST + bulk_remove=off [PPC] This parameter disables the use of the pSeries + firmware feature for flushing multiple hpte entries + at a time. + c101= [NET] Moxa C101 synchronous serial card cachesize= [BUGS=X86-32] Override level 2 CPU cache size detection. @@ -655,11 +654,6 @@ and is between 256 and 4096 characters. It is defined in the file dscc4.setup= [NET] - dynamic_printk Enables pr_debug()/dev_dbg() calls if - CONFIG_DYNAMIC_PRINTK_DEBUG has been enabled. - These can also be switched on/off via - <debugfs>/dynamic_printk/modules - earlycon= [KNL] Output early console device and options. uart[8250],io,<addr>[,options] uart[8250],mmio,<addr>[,options] @@ -884,6 +878,7 @@ and is between 256 and 4096 characters. It is defined in the file controller i8042.nopnp [HW] Don't use ACPIPnP / PnPBIOS to discover KBD/AUX controllers + i8042.notimeout [HW] Ignore timeout condition signalled by conroller i8042.reset [HW] Reset the controller during init and cleanup i8042.unlock [HW] Unlock (ignore) the keylock @@ -1490,6 +1485,10 @@ and is between 256 and 4096 characters. It is defined in the file mtdparts= [MTD] See drivers/mtd/cmdlinepart.c. + multitce=off [PPC] This parameter disables the use of the pSeries + firmware feature for updating multiple TCE entries + at a time. + onenand.bdry= [HW,MTD] Flex-OneNAND Boundary Configuration Format: [die0_boundary][,die0_lock][,die1_boundary][,die1_lock] @@ -1701,6 +1700,9 @@ and is between 256 and 4096 characters. It is defined in the file no-kvmclock [X86,KVM] Disable paravirtualized KVM clock driver + no-kvmapf [X86,KVM] Disable paravirtualized asynchronous page + fault handling. + nolapic [X86-32,APIC] Do not enable or use the local APIC. nolapic_timer [X86-32,APIC] Do not use the local APIC timer. |