summaryrefslogtreecommitdiff
path: root/Documentation
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation')
-rw-r--r--Documentation/dmatest.txt6
1 files changed, 3 insertions, 3 deletions
diff --git a/Documentation/dmatest.txt b/Documentation/dmatest.txt
index 279ac0a8c5b1..132a094c7bc3 100644
--- a/Documentation/dmatest.txt
+++ b/Documentation/dmatest.txt
@@ -34,7 +34,7 @@ command:
After a while you will start to get messages about current status or error like
in the original code.
-Note that running a new test will stop any in progress test.
+Note that running a new test will not stop any in progress test.
The following command should return actual state of the test.
% cat /sys/kernel/debug/dmatest/run
@@ -52,8 +52,8 @@ To wait for test done the user may perform a busy loop that checks the state.
The module parameters that is supplied to the kernel command line will be used
for the first performed test. After user gets a control, the test could be
-interrupted or re-run with same or different parameters. For the details see
-the above section "Part 2 - When dmatest is built as a module..."
+re-run with the same or different parameters. For the details see the above
+section "Part 2 - When dmatest is built as a module..."
In both cases the module parameters are used as initial values for the test case.
You always could check them at run-time by running