diff options
Diffstat (limited to 'arch/arm/boot/dts/imx6ull-colibri-aster.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/imx6ull-colibri-aster.dtsi | 28 |
1 files changed, 1 insertions, 27 deletions
diff --git a/arch/arm/boot/dts/imx6ull-colibri-aster.dtsi b/arch/arm/boot/dts/imx6ull-colibri-aster.dtsi index 93367e89466e..e7d6da210dc1 100644 --- a/arch/arm/boot/dts/imx6ull-colibri-aster.dtsi +++ b/arch/arm/boot/dts/imx6ull-colibri-aster.dtsi @@ -107,11 +107,6 @@ }; }; -/* ATMEL TS connector */ -&atmel_mxt_ts { - status = "okay"; -}; - /* PWM <A> */ &pwm4 { status = "okay"; @@ -155,28 +150,7 @@ status = "okay"; }; -/* The define SD_1_8 allows to use the SD interface at a higher speed mode - * if the card supports it. For this the signaling voltage is switched from - * 3.3V to 1.8V under the usdhc1's drivers control. - */ -/* #define SD_1_8 */ &usdhc1 { -#ifdef SD_1_8 - pinctrl-names = "default", "state_100mhz", "state_200mhz", "sleep"; - pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd>; - pinctrl-1 = <&pinctrl_usdhc1_100mhz &pinctrl_snvs_usdhc1_cd>; - pinctrl-2 = <&pinctrl_usdhc1_200mhz &pinctrl_snvs_usdhc1_cd>; - pinctrl-3 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd_sleep>; - vqmmc-supply = <®_sd1_vqmmc>; -#else - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd>; - no-1-8-v; -#endif - cd-gpios = <&gpio5 0 GPIO_ACTIVE_LOW>; - disable-wp; - enable-sdio-wakeup; - keep-power-in-suspend; - status = "okay"; vmmc-supply = <®_3v3>; + status = "okay"; }; |