diff options
Diffstat (limited to 'arch/arm/boot/dts/imx6ull-colibri-eval-v3.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/imx6ull-colibri-eval-v3.dtsi | 26 |
1 files changed, 2 insertions, 24 deletions
diff --git a/arch/arm/boot/dts/imx6ull-colibri-eval-v3.dtsi b/arch/arm/boot/dts/imx6ull-colibri-eval-v3.dtsi index 99f9b1fb15c5..821523a12423 100644 --- a/arch/arm/boot/dts/imx6ull-colibri-eval-v3.dtsi +++ b/arch/arm/boot/dts/imx6ull-colibri-eval-v3.dtsi @@ -123,8 +123,8 @@ &atmel_mxt_ts { pinctrl-0 = <&pinctrl_atmel_adap>; interrupt-parent = <&gpio4>; - interrupts = <16 IRQ_TYPE_EDGE_FALLING>; - reset-gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; + interrupts = <16 IRQ_TYPE_EDGE_FALLING>; /* SODIMM 28, INT */ + reset-gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; /* SODIMM 30, RST */ status = "disabled"; }; @@ -176,29 +176,7 @@ status = "okay"; }; -/* The define SD_1_8 allows to use the SD interface at a higher speed mode - * if the card supports it. For this the signaling voltage is switched from - * 3.3V to 1.8V under the usdhc1's drivers control. - */ -/* #define SD_1_8 */ &usdhc1 { -#ifdef SD_1_8 - pinctrl-names = "default", "state_100mhz", "state_200mhz", "sleep"; - pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd>; - pinctrl-1 = <&pinctrl_usdhc1_100mhz &pinctrl_snvs_usdhc1_cd>; - pinctrl-2 = <&pinctrl_usdhc1_200mhz &pinctrl_snvs_usdhc1_cd>; - pinctrl-3 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd_sleep>; -#else - pinctrl-names = "default", "sleep"; - pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd>; - pinctrl-1 = <&pinctrl_usdhc1 &pinctrl_snvs_usdhc1_cd_sleep>; - no-1-8-v; -#endif - cd-gpios = <&gpio5 0 GPIO_ACTIVE_LOW>; - vqmmc-supply = <®_sd1_vqmmc>; - disable-wp; - wakeup-source; - keep-power-in-suspend; vmmc-supply = <®_3v3>; status = "okay"; }; |