diff options
Diffstat (limited to 'arch/arm/boot/dts/imx7-colibri-aster.dtsi')
-rw-r--r-- | arch/arm/boot/dts/imx7-colibri-aster.dtsi | 25 |
1 files changed, 1 insertions, 24 deletions
diff --git a/arch/arm/boot/dts/imx7-colibri-aster.dtsi b/arch/arm/boot/dts/imx7-colibri-aster.dtsi index 0aa282ca4a29..0469ca23d8d3 100644 --- a/arch/arm/boot/dts/imx7-colibri-aster.dtsi +++ b/arch/arm/boot/dts/imx7-colibri-aster.dtsi @@ -135,31 +135,8 @@ status = "okay"; }; -/* The define SD_1_8 allows to use the SD interface at a higher speed mode - * if the card supports it. For this the signaling voltage is switched from - * 3.3V to 1.8V under the usdhc1's drivers control. - * All pins supplied with NVCC_SD1 must be able to cope with this - * and must (MUST!!!) not be driven with a voltage higher than 1.8V or - * the interface will not work. - */ -/* #define SD_1_8 */ &usdhc1 { -#ifdef SD_1_8 - pinctrl-names = "default", "state_100mhz", "state_200mhz"; - pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_cd_usdhc1>; - pinctrl-1 = <&pinctrl_usdhc1_100mhz &pinctrl_cd_usdhc1>; - pinctrl-2 = <&pinctrl_usdhc1_200mhz &pinctrl_cd_usdhc1>; - vmmc-supply = <®_3p3v>; - vqmmc-supply = <®_LDO2>; -#else - pinctrl-names = "default"; - pinctrl-0 = <&pinctrl_usdhc1 &pinctrl_cd_usdhc1>; - no-1-8-v; -#endif - cd-gpios = <&gpio1 0 GPIO_ACTIVE_LOW>; - disable-wp; - enable-sdio-wakeup; - keep-power-in-suspend; + vmmc-supply = <®_3v3>; status = "okay"; }; |