linux-toradex.git - Linux kernel for Apalis, Colibri and Verdin modules

Age	Commit message (Collapse)	Author
2016-03-29	ARM: dts: ux500: use the GPIO DT header	Linus Walleij
	Use the <dt-bindings/gpio/gpio.h> header instead of using hardcoded values for the GPIO flags. Eradicate the totally bogus "0x4" flag used and set that to GPIO_ACTIVE_HIGH as is proper, switch the inverted card detect on the Snowball to flag using GPIO_ACTIVE_LOW instead of using the MMC-specific inversion flag. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2015-11-17	ARM: ux500: push down Rohm TS to STUIB	Linus Walleij
	The Rohm touchscreen reset and IRQ lines were registered and configured at the HREF board level of the design, but it is an integral part of the UIB (User Interface Board). Fix this by pushing down the pin control node to the u8500 UIB file. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2015-05-13	ARM: ux500: add the sensors to the STUIB board	Linus Walleij
	This adds the device tree data for the LIS331DL and the AK8974 magnetometer to the STUIB board device tree include file. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2014-10-20	pinctrl: nomadik: force-convert to generic config bindings	Linus Walleij
	This converts the Nomadik pin controller and all associated device trees to use the standard, generic config bindings for pin controllers. There are no such device trees deployed in the wild so this is safe to do to set a good example. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2014-07-07	ARM: ux500: add VCC and VIO regulators to STMPE IC	Linus Walleij
	Add a VCC and VIO regulator supplies to the the STMPE expander found on the STUIB UIB variants. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2013-11-26	ARM: ux500: move GPIO key configuration to device tree	Linus Walleij
	This moves over the configuration of the GPIO keys (used for proximity sensor and Hall effect sensor) from the static pin configuration file to the device tree. As part of the exercise, implement the GPIO keys properly in a per-UIB file as this setup actually differs with each UIB. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2013-10-03	ARM: ux500: move BU21013 touchpad GPIOs into top-level DTS	Linus Walleij
	The BU21013 touchscreen GPIOs have been pretty confused, correct them per board, and move the GPIO assignments up to the top level DTS file so we can control it from there, and avoid defining the GPIO assignments for non-ST UIB equipped boards. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
2013-10-02	ARM: ux500: split HREF UIB files	Linus Walleij
	Create two different UIB (User Interface Board) include files: one per UIB simply. The include files now only handle the devices on that very UIB. Signed-off-by: Linus Walleij <linus.walleij@linaro.org>