Age | Commit message (Collapse) | Author |
|
Remove vdd_hdmi_con regulator from dc1 since we don't have a dedicated
regulator for this connector on our baseboards.
|
|
Use TPS6591X base defines to make sure the chip gets its own irq range rather
than interfer with the STMPE chip.
|
|
3.3V consumers
|
|
PLLE: now supplied by LDO6 - Put the limits of the supplied circuit as constraints - Moved derived rails from 1.8V to 3.3V where applicable
|
|
|
|
Can be initiated both by LXDE Logout - Suspend or manually doing
'echo mem > /sys/power/state'. Uses GPIO key power (SODIMM pin 45,
Iris X16-20) as wake-up source. If woken-up LXDE session does not
automatically activate desktop again try manually doing a 'chvt 7'.
|
|
Integrate ALSA SoC SGTL5000 codec on Toradex Colibri T30.
|
|
Tested on early prototype Colibri T30 V1.0a eMMC module.
Known issues:
- spurious boot hang after following kernel message
[ 5.595219] Timed out waiting for lock bit on pll pll_a
- no audio (SGTL5000) support integrated yet
- NAND detection/support disabled for now due to boot hang
- USB OTG support disabled for now due to boot hang
- trying to spawn L4T R16 X driver seems to hang
Note: requires uImage with adjusted entry point/load address as follows
mkimage -A arm -C none -O linux -T kernel -a 0x82008000 -e 0x82008000 -n 'Linux-3.1.10-colibri_t30' -d zImage uImage
|