summaryrefslogtreecommitdiff
path: root/sound/pci/oxygen/xonar_pcm179x.c
AgeCommit message (Collapse)Author
2011-07-18ALSA: virtuoso: fix silent analog output on Xonar Essence ST DeluxeClemens Ladisch
Commit dd203fa97bd5 (ALSA: virtuoso: remove non-working controls on Essence ST Deluxe) made it impossible to adjust the volume after the driver initialized it to muted. Ensure that those DACs that can be accessed with I2C are initialized to the same volume that is the reset default of the DAC without I2C. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Cc: 2.6.38+ <stable@kernel.org>
2011-01-10ALSA: core, oxygen, virtuoso: add an enum control info helperClemens Ladisch
Introduce the helper function snd_ctl_enum_info() to fill out the elem_info fields for an enumerated control. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: add Xonar HDAV1.3 Slim supportClemens Ladisch
Add experimental support for the Asus Xonar HDAV1.3 Slim sound card. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: reduce MCLK in double rate modesClemens Ladisch
For the CSxxxx and AKxxxx DAC/ADC chips, the MCLK factor in double rate modes (64-96 kHz) can be reduced to 128x without reducing sound quality. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: oxygen: simplify model-specific MCLK handlingClemens Ladisch
Replace the get_i2s_mclk callback with tables of MCLK values. This simplifies the MCLK-handling code in both the framework and the model- specific drivers. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: use headphone gain setting only on front DACClemens Ladisch
Do not apply the headphone gain offset to any but the front DAC. These DACs would not be used in headphone mode, so this saves a few register writes. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: handle DAC oversampling automaticallyClemens Ladisch
Remove the DAC Oversampling mixer control because this setting does not make much sense. For cards with the H6 daughterboard, 128x oversampling was disabled anyway because these high MCLK frequency would not be compatible with the connector cable. For cards without the H6 daughterboard, 128x gives a slightly higher output quality; there is no reason to reduce it to 64x except for saving power, but then these cards have not been designed to be power efficient anyway (the D2's blinkenlights cannot be disabled). Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: use lower master clock with H6 daughterboardClemens Ladisch
Because of the unshielded connector cable, it is important to use as low a master clock frequency as possible with the H6. For double rate modes (64-96 kHz), the MCLK rate is unconditionally lowered from 512x to 256x because the higher rate would not improve anything. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: configure correct master clock frequency on the CS2000Clemens Ladisch
The clock output of the CS2000, which is used as master clock for the DACs, was using half the actual master clock frequency for some reason. Using the theoretically correct frequency seems also to work in practice. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: remove non-working controls on Essence ST DeluxeClemens Ladisch
On the Xonar Essence ST Deluxe, remove all mixer controls that would require I2C communication with the third DAC, which does not work because of an addressing conflict with the CS2000 chip. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: change PCM1796 format to I2SClemens Ladisch
Change the PCM format used for the PCM1796 from left-justified to I2S to ensure that the correct format is used even for the Essence ST Deluxe's center/LFE DAC, where I2C does not work because of an address conflict with the CS2000 chip. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: wait for PCM1796 clock to become stableClemens Ladisch
The PCM1796 needs the master clock for I2C communication to work, so add delays after clock changes to ensure that the clock is stable when we try to write the DACs' registers. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: virtuoso: do not use fast I2C speedClemens Ladisch
To make the I2C communication reliable when using the H6 daughterboard, reduce the I2C clock frequency. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: oxygen: remove oxygen_model::private_data fieldClemens Ladisch
The number of DACs can now be deduced from the dac_channels_mixer field, so the private_data field is no longer needed. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2011-01-10ALSA: oxygen: allow different number of PCM and mixer channelsClemens Ladisch
For cards like the Xonar HDAV1.3, differentiate between the number of PCM channels that can be played and the number of channels whose volume can be adjusted. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-12-06ALSA: oxygen: update hardware commentsClemens Ladisch
Reformat and update the comments that describe the hardware connections on the various models. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-12-06ALSA: oxygen: allow to dump codec registersClemens Ladisch
To help with debugging, add the registers of the model-specific codecs to the controller and AC97 register dump in the proc file. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-12-06ALSA: virtuoso: fix front panel routing for D1/DX/ST(X)Clemens Ladisch
The "Front Panel" switch on the Xonar D1/DX actually switches only the output direction, so mark it appropriately. The front panel microphone is controlled by the FMIC2MIC bit of the CM9780. It was unconditionally enabled on the D1/DX and never set on the ST(X); add a control for it. Selecting the front panel microphone as source does not actually disable the microphone jack, but this is bug-compatible with the Windows driver, and users rely on it. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-12-06ALSA: virtuoso: add HDMI enable switch for HDAV1.3Clemens Ladisch
The GPIO bit that enables analog output on the Xonar HDAV1.3 also disables the HDMI audio output, so we better add a switch for it. Hopefully, this is sufficient to make the HDMI output work. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-12-06ALSA: virtuoso: initialize unknown GPIO bitsClemens Ladisch
Initialize the configuration of some unknown GPIO output bits (that might not be used at all) to be the same as in the Windows driver, just to be sure. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-10-05ALSA: virtuoso: fix Xonar STX anti-pop delayClemens Ladisch
The anti-pop delay for the STX should be 800 ms, not 100 ms like the ST. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-10-05ALSA: virtuoso: add HDAV1.3 Slim PCI IDClemens Ladisch
Add a PCI ID for the Xonar HDAV1.3 Slim. There is no actual support, but the presence of the ID allows the EEPROM repair code to work for this card. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2010-10-05ALSA: oxygen: handle CD input configuration with a flagClemens Ladisch
There are more models without a CD input than with one, so handle this explicitly with a device_config flag to avoid having to define a control filter callback to filter it out. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: oxygen: add digital filter controlClemens Ladisch
Add a control to select between sharp and slow roll-of filter responses of the DACs. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: virtuoso: add PCM1796 oversampling controlClemens Ladisch
Add a control to increase the oversampling factor to 128x on cards with PCM1796 or PCM1792A DACs. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: oxygen: allow custom MCLK ratesClemens Ladisch
Add a callback that allows model drivers to modify the default I2S MCLK rate. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: virtuoso: add headphone impedance controlClemens Ladisch
Add a mixer control to adjust the headphone amplifier output for headphones with different impedances. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: oxygen: cache codec registersClemens Ladisch
Keep a cache of codec registers to avoid unnecessary writes. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: oxygen: more hardware documentationClemens Ladisch
Add some comments describing the hardware pin routing. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: oxygen: better defaults for upmixing controlClemens Ladisch
On card models with two-channel outputs, the base driver can automatically disable the upmixing control so that the model drivers do not need to do this. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: virtuoso: fix Xonar Essence ST supportClemens Ladisch
The Essence ST uses the CS2000 chip to generate the DAC master clock, so we better initialize and program it appropriately. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
2009-09-28sound: virtuoso: split virtuoso.cClemens Ladisch
The virtuoso.c file has become rather big. This patch splits it up so that only code for very similar card models is in one file. Signed-off-by: Clemens Ladisch <clemens@ladisch.de> Signed-off-by: Takashi Iwai <tiwai@suse.de>
generated by cgit v1.2.3 (git 2.0.4) at 2024-06-24 14:03:40 +0000