From c5114a1cd6d84b2b3144c1c3e093c80ca6c30f47 Mon Sep 17 00:00:00 2001 From: Clemens Ladisch Date: Sun, 10 Jan 2010 20:52:34 +0100 Subject: hwmon: (k10temp) Blacklist more family 10h processors The latest version of the Revision Guide for AMD Family 10h Processors lists two more processor revisions which may be affected by erratum 319. Change the blacklisting code to correctly detect those processors, by implementing AMD's recommended algorithm. Signed-off-by: Clemens Ladisch Signed-off-by: Jean Delvare Cc: Andreas Herrmann --- Documentation/hwmon/k10temp | 17 +++++++++++------ 1 file changed, 11 insertions(+), 6 deletions(-) (limited to 'Documentation/hwmon') diff --git a/Documentation/hwmon/k10temp b/Documentation/hwmon/k10temp index a7a18d453a51..6526eee525a6 100644 --- a/Documentation/hwmon/k10temp +++ b/Documentation/hwmon/k10temp @@ -3,8 +3,8 @@ Kernel driver k10temp Supported chips: * AMD Family 10h processors: - Socket F: Quad-Core/Six-Core/Embedded Opteron - Socket AM2+: Opteron, Phenom (II) X3/X4 + Socket F: Quad-Core/Six-Core/Embedded Opteron (but see below) + Socket AM2+: Quad-Core Opteron, Phenom (II) X3/X4, Athlon X2 (but see below) Socket AM3: Quad-Core Opteron, Athlon/Phenom II X2/X3/X4, Sempron II Socket S1G3: Athlon II, Sempron, Turion II * AMD Family 11h processors: @@ -36,10 +36,15 @@ Description This driver permits reading of the internal temperature sensor of AMD Family 10h and 11h processors. -All these processors have a sensor, but on older revisions of Family 10h -processors, the sensor may return inconsistent values (erratum 319). The -driver will refuse to load on these revisions unless you specify the -"force=1" module parameter. +All these processors have a sensor, but on those for Socket F or AM2+, +the sensor may return inconsistent values (erratum 319). The driver +will refuse to load on these revisions unless you specify the "force=1" +module parameter. + +Due to technical reasons, the driver can detect only the mainboard's +socket type, not the processor's actual capabilities. Therefore, if you +are using an AM3 processor on an AM2+ mainboard, you can safely use the +"force=1" parameter. There is one temperature measurement value, available as temp1_input in sysfs. It is measured in degrees Celsius with a resolution of 1/8th degree. -- cgit v1.2.3