From 952a5db0c0f8ddf9776c84e818769f5c6e97ec38 Mon Sep 17 00:00:00 2001 From: Tony Lindgren Date: Fri, 9 Sep 2016 14:04:28 -0700 Subject: ARM: dts: Configure omap5 OTG ID pin The ID pin GPIO comes from the PMIC. Let's configure it as a GPIO for the driver to use, and also make sure the PMIC GPIO pin muxing is correct. The PMIC pad1 and 2 values for omap5-uevm and igepv5 are 0x5a and 0x1b, we only need to clear bit 2 in pad1 register to make the ID pin GPIO work. Signed-off-by: Tony Lindgren --- arch/arm/boot/dts/omap5-board-common.dtsi | 9 +++++++++ arch/arm/boot/dts/omap5.dtsi | 2 +- 2 files changed, 10 insertions(+), 1 deletion(-) (limited to 'arch/arm/boot') diff --git a/arch/arm/boot/dts/omap5-board-common.dtsi b/arch/arm/boot/dts/omap5-board-common.dtsi index cb3247f19b9f..c61eb2063be8 100644 --- a/arch/arm/boot/dts/omap5-board-common.dtsi +++ b/arch/arm/boot/dts/omap5-board-common.dtsi @@ -393,14 +393,23 @@ interrupt-controller; #interrupt-cells = <2>; ti,system-power-controller; + ti,mux-pad1 = <0xa1>; + ti,mux-pad2 = <0x1b>; pinctrl-names = "default"; pinctrl-0 = <&palmas_sys_nirq_pins &palmas_msecure_pins>; + palmas_gpio: gpio { + compatible = "ti,palmas-gpio"; + gpio-controller; + #gpio-cells = <2>; + }; + extcon_usb3: palmas_usb { compatible = "ti,palmas-usb-vid"; ti,enable-vbus-detection; ti,enable-id-detection; ti,wakeup; + id-gpios = <&palmas_gpio 0 GPIO_ACTIVE_HIGH>; }; clk32kgaudio: palmas_clk32k@1 { diff --git a/arch/arm/boot/dts/omap5.dtsi b/arch/arm/boot/dts/omap5.dtsi index 71a8f5492c8b..c2ef1285a3dd 100644 --- a/arch/arm/boot/dts/omap5.dtsi +++ b/arch/arm/boot/dts/omap5.dtsi @@ -863,7 +863,7 @@ #size-cells = <1>; utmi-mode = <2>; ranges; - dwc3@4a030000 { + dwc3: dwc3@4a030000 { compatible = "snps,dwc3"; reg = <0x4a030000 0x10000>; interrupts = , -- cgit v1.2.3