// SPDX-License-Identifier: GPL-2.0 /dts-v1/; #include "kirkwood.dtsi" #include "kirkwood-6281.dtsi" / { model = "Seagate FreeAgent Dockstar"; compatible = "seagate,dockstar", "marvell,kirkwood-88f6281", "marvell,kirkwood"; memory { device_type = "memory"; reg = <0x00000000 0x8000000>; }; chosen { bootargs = "console=ttyS0,115200n8 earlyprintk root=/dev/sda1 rootdelay=10"; stdout-path = &uart0; }; ocp@f1000000 { pinctrl: pin-controller@10000 { pmx_usb_power_enable: pmx-usb-power-enable { marvell,pins = "mpp29"; marvell,function = "gpio"; }; pmx_led_green: pmx-led-green { marvell,pins = "mpp46"; marvell,function = "gpio"; }; pmx_led_orange: pmx-led-orange { marvell,pins = "mpp47"; marvell,function = "gpio"; }; }; serial@12000 { status = "ok"; }; }; gpio-leds { compatible = "gpio-leds"; pinctrl-0 = <&pmx_led_green &pmx_led_orange>; pinctrl-names = "default"; health { label = "status:green:health"; gpios = <&gpio1 14 GPIO_ACTIVE_LOW>; default-state = "keep"; }; fault { label = "status:orange:fault"; gpios = <&gpio1 15 GPIO_ACTIVE_LOW>; }; }; regulators { compatible = "simple-bus"; #address-cells = <1>; #size-cells = <0>; pinctrl-0 = <&pmx_usb_power_enable>; pinctrl-names = "default"; usb_power: regulator@1 { compatible = "regulator-fixed"; reg = <1>; regulator-name = "USB Power"; regulator-min-microvolt = <5000000>; regulator-max-microvolt = <5000000>; enable-active-high; regulator-always-on; regulator-boot-on; gpio = <&gpio0 29 0>; }; }; }; &nand { status = "okay"; partition@0 { label = "u-boot"; reg = <0x0000000 0x100000>; read-only; }; partition@100000 { label = "uImage"; reg = <0x0100000 0x400000>; }; partition@500000 { label = "data"; reg = <0x0500000 0xfb00000>; }; }; &mdio { status = "okay"; ethphy0: ethernet-phy@0 { compatible = "marvell,88e1116"; reg = <0>; }; }; ð0 { status = "okay"; ethernet0-port@0 { phy-handle = <ðphy0>; }; };