/* SPDX-License-Identifier: GPL-2.0-or-later */ /* * arch/arm/mach-pxa/include/mach/pcm027.h * * (c) 2003 Phytec Messtechnik GmbH * (c) 2007 Juergen Beisert */ /* * Definitions of CPU card resources only */ #include /* PXA_GPIO_TO_IRQ */ /* phyCORE-PXA270 (PCM027) Interrupts */ #define PCM027_IRQ(x) (IRQ_BOARD_START + (x)) #define PCM027_BTDET_IRQ PCM027_IRQ(0) #define PCM027_FF_RI_IRQ PCM027_IRQ(1) #define PCM027_MMCDET_IRQ PCM027_IRQ(2) #define PCM027_PM_5V_IRQ PCM027_IRQ(3) #define PCM027_NR_IRQS (IRQ_BOARD_START + 32) /* I2C RTC */ #define PCM027_RTC_IRQ_GPIO 0 #define PCM027_RTC_IRQ PXA_GPIO_TO_IRQ(PCM027_RTC_IRQ_GPIO) #define PCM027_RTC_IRQ_EDGE IRQ_TYPE_EDGE_FALLING #define ADR_PCM027_RTC 0x51 /* I2C address */ /* I2C EEPROM */ #define ADR_PCM027_EEPROM 0x54 /* I2C address */ /* Ethernet chip (SMSC91C111) */ #define PCM027_ETH_IRQ_GPIO 52 #define PCM027_ETH_IRQ PXA_GPIO_TO_IRQ(PCM027_ETH_IRQ_GPIO) #define PCM027_ETH_IRQ_EDGE IRQ_TYPE_EDGE_RISING #define PCM027_ETH_PHYS PXA_CS5_PHYS #define PCM027_ETH_SIZE (1*1024*1024) /* CAN controller SJA1000 (unsupported yet) */ #define PCM027_CAN_IRQ_GPIO 114 #define PCM027_CAN_IRQ PXA_GPIO_TO_IRQ(PCM027_CAN_IRQ_GPIO) #define PCM027_CAN_IRQ_EDGE IRQ_TYPE_EDGE_FALLING #define PCM027_CAN_PHYS 0x22000000 #define PCM027_CAN_SIZE 0x100 /* SPI GPIO expander (unsupported yet) */ #define PCM027_EGPIO_IRQ_GPIO 27 #define PCM027_EGPIO_IRQ PXA_GPIO_TO_IRQ(PCM027_EGPIO_IRQ_GPIO) #define PCM027_EGPIO_IRQ_EDGE IRQ_TYPE_EDGE_FALLING #define PCM027_EGPIO_CS 24 /* * TODO: Switch this pin from dedicated usage to GPIO if * more than the MAX7301 device is connected to this SPI bus */ #define PCM027_EGPIO_CS_MODE GPIO24_SFRM_MD /* Flash memory */ #define PCM027_FLASH_PHYS 0x00000000 #define PCM027_FLASH_SIZE 0x02000000 /* onboard LEDs connected to GPIO */ #define PCM027_LED_CPU 90 #define PCM027_LED_HEARD_BEAT 91 /* * This CPU module needs a baseboard to work. After basic initializing * its own devices, it calls baseboard's init function. * TODO: Add your own basebaord init function and call it from * inside pcm027_init(). This example here is for the developmen board. * Refer pcm990-baseboard.c */ extern void pcm990_baseboard_init(void);