diff options
Diffstat (limited to 'README')
| -rw-r--r-- | README | 49 |
1 files changed, 0 insertions, 49 deletions
@@ -3509,21 +3509,6 @@ FIT uImage format: CONFIG_SPL_INIT_MINIMAL Arch init code should be built for a very small image - CONFIG_SPL_LIBCOMMON_SUPPORT - Support for common/libcommon.o in SPL binary - - CONFIG_SPL_LIBDISK_SUPPORT - Support for disk/libdisk.o in SPL binary - - CONFIG_SPL_I2C_SUPPORT - Support for drivers/i2c/libi2c.o in SPL binary - - CONFIG_SPL_GPIO_SUPPORT - Support for drivers/gpio/libgpio.o in SPL binary - - CONFIG_SPL_MMC_SUPPORT - Support for drivers/mmc/libmmc.o in SPL binary - CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR, CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS, Address and partition on the MMC to load U-Boot from @@ -3547,12 +3532,6 @@ FIT uImage format: Partition on the MMC to load U-Boot from when the MMC is being used in fs mode - CONFIG_SPL_FAT_SUPPORT - Support for fs/fat/libfat.o in SPL binary - - CONFIG_SPL_EXT_SUPPORT - Support for EXT filesystem in SPL binary - CONFIG_SPL_FS_LOAD_PAYLOAD_NAME Filename to read to load U-Boot when reading from filesystem @@ -3591,18 +3570,10 @@ FIT uImage format: Support for a lightweight UBI (fastmap) scanner and loader - CONFIG_SPL_MTD_SUPPORT - Support for the MTD subsystem within SPL. Useful for - environment on NAND support within SPL. - CONFIG_SPL_NAND_RAW_ONLY Support to boot only raw u-boot.bin images. Use this only if you need to save space. - CONFIG_SPL_MPC8XXX_INIT_DDR_SUPPORT - Set for the SPL on PPC mpc8xxx targets, support for - drivers/ddr/fsl/libddr.o in SPL binary. - CONFIG_SPL_COMMON_INIT_DDR Set for common ddr init with serial presence detect in SPL binary. @@ -3638,29 +3609,9 @@ FIT uImage format: Support for an OMAP3-specific set of functions to return the ID and MFR of the first attached NAND chip, if present. - CONFIG_SPL_SERIAL_SUPPORT - Support for drivers/serial/libserial.o in SPL binary - - CONFIG_SPL_SPI_FLASH_SUPPORT - Support for drivers/mtd/spi/libspi_flash.o in SPL binary - - CONFIG_SPL_SPI_SUPPORT - Support for drivers/spi/libspi.o in SPL binary - CONFIG_SPL_RAM_DEVICE Support for running image already present in ram, in SPL binary - CONFIG_SPL_LIBGENERIC_SUPPORT - Support for lib/libgeneric.o in SPL binary - - CONFIG_SPL_ENV_SUPPORT - Support for the environment operating in SPL binary - - CONFIG_SPL_NET_SUPPORT - Support for the net/libnet.o in SPL binary. - It conflicts with SPL env from storage medium specified by - CONFIG_ENV_IS_xxx but CONFIG_ENV_IS_NOWHERE - CONFIG_SPL_PAD_TO Image offset to which the SPL should be padded before appending the SPL payload. By default, this is defined as |