summaryrefslogtreecommitdiff
path: root/board
AgeCommit message (Expand)Author
2020-05-07colibri-imx6ull: fix lcd_pads, provide vsync muxColibri-iMX7_LXDE-Image_2.8b7.-20200610Colibri-iMX6_LXDE-Image_2.8b7.-20200610Colibri-iMX6ULL_LXDE-Image_2.8b7.-20200610Colibri-VF_LXDE-Image_2.8b7.-20200610Colibri-T30_LXDE-Image_2.8b7.-20200610Colibri-T20_LXDE-Image_2.8b7.-20200610Apalis-iMX6_LXDE-Image_2.8b7.-20200610Apalis-TK1_LXDE-Image_2.8b7.-20200610Apalis-TK1-Mainline_LXDE-Image_2.8b7.-20200610Apalis-T30_LXDE-Image_2.8b7.-20200610Igor Opaniuk
2020-03-09apalis_t30: apalis-tk1: update tezi vidargs for drmMarcel Ziswiler
2020-03-05fitimage: adapt to the changes in tezi meta layerMing Liu
2019-07-19colibri_imx6: provide usb phy mode funcIgor Opaniuk
2019-04-24colibri_imx6ull: fix USBC_DET pin configurationIgor Opaniuk
2019-04-05colibri_vf: disable ODT in PHY settingsStefan Agner
2019-04-05Revert "colibri-vf: disable ODT"Stefan Agner
2019-04-05colibri_vf: use recommended PHY lock detect values from datasheetStefan Agner
2019-03-04colibri-vf: disable ODTColibri-iMX7_LXDE-Image_2.8b6.184-20190401Colibri-iMX6_LXDE-Image_2.8b6.184-20190401Colibri-iMX6ULL_LXDE-Image_2.8b6.184-20190401Colibri-VF_LXDE-Image_2.8b6.183-20190331Colibri-T30_LXDE-Image_2.8b6.184-20190401Colibri-T20_LXDE-Image_2.8b6.184-20190401Apalis-iMX6_LXDE-Image_2.8b6.184-20190401Apalis-TK1_LXDE-Image_2.8b6.184-20190401Apalis-TK1-Mainline_LXDE-Image_2.8b6.184-20190401Apalis-T30_LXDE-Image_2.8b6.184-20190401Stefan Agner
2018-12-20phy: ksz9031: Center FLP timing at 16msPhilippe Schenker
2018-12-20board: imx6ull: Add disable PMIC_STBY_REQPhilippe Schenker
2018-11-27colibri_imx7: explicitly set flash detection pin as inputStefan Agner
2018-11-27colibri_imx7: fix comments about memory alignment requirementsStefan Agner
2018-09-28colibri-imx6ull: fix ethernet phy power onMarcel Ziswiler
2018-09-28colibri imx6: use dynamic ddr calibrationMax Krummenacher
2018-09-20mx6: ddr: pass mx6_ddr_sysinfo to calibration routinesEric Nelson
2018-09-20colibri_imx6: apply nreset_out only if no power-onStefan Bigler
2018-09-20mtd: nand: colibri_t20: more comments/debug outputMarcel Ziswiler
2018-09-13board: toradex: turn off lcd backlight before OS handoverGerard Salvatella
2018-09-13board: apalis/colibri_imx6: check for and report ecc errors in fusesGerard Salvatella
2018-07-27apalis-tk1: remove non-esential power rails on bootDominik Sliwa
2018-07-27apalis_t30: integrate tezi recoveryMarcel Ziswiler
2018-07-27apalis-tk1: integrate tezi recoveryMarcel Ziswiler
2018-07-27colibri_imx7: add configuration for tezi recoveryStefan Agner
2018-07-27apalis_imx6: add configuration for teziStefan Agner
2018-07-27toradex: add easy installer configurabilityMarcel Ziswiler
2018-06-19colibri-imx6ull: set module variant depending on config blockStefan Agner
2018-06-19tdx-cfg-block: simplify i.MX 6 module detectionStefan Agner
2018-06-18tdx-cfg-block: add support for new Colibri iMX6ULL SKUsGerard Salvatella
2018-06-18colibri-vf: use leveling evaluated by DDR validation toolsStefan Agner
2018-06-18colibri-vf: adjust timing according to data sheetStefan Agner
2018-06-06colibri-imx6: added nreset gpio on rebootGerard Salvatella
2018-06-06colibri-imx6ull: fix card detect GPIO of SD cardStefan Agner
2018-06-06colibri-imx6ull: Set the DDR RAM ASR bitSven Guggisberg
2018-06-06tdx-cfg-block: fix off by one issueMarcel Ziswiler
2018-03-21colibri_t20: fix passing mac address via dtColibri-iMX7_LXDE-Image_2.8b2.97-20180331Colibri-iMX6_LXDE-Image_2.8b2.97-20180331Colibri-iMX6ULL_LXDE-Image_2.8b2.97-20180331Colibri-VF_LXDE-Image_2.8b2.97-20180331Colibri-T30_LXDE-Image_2.8b2.97-20180331Colibri-T20_LXDE-Image_2.8b2.97-20180331Apalis-iMX6_LXDE-Image_2.8b2.97-20180331Apalis-TK1_LXDE-Image_2.8b2.97-20180331Apalis-TK1-Mainline_LXDE-Image_2.8b2.97-20180331Apalis-T30_LXDE-Image_2.8b2.97-20180331Marcel Ziswiler
2018-03-21apalis_t30/tk1/colibri_t20/t30: integrate mac address via dtMarcel Ziswiler
2018-03-21colibri_t20: integrate mtd partitions via dtMarcel Ziswiler
2018-03-21tdx-cfg-block: add new SKUsStefan Agner
2018-03-21colibri-imx6ull: add MTD fixup compatible for mainline kernelsStefan Agner
2018-03-20colibri_imx7: do not mux SODIMM 169 as NAND chip selectStefan Agner
2017-11-27colibri_imx6ull: add dtb for wifi variantMax Krummenacher
2017-11-27colibri_imx6ull.c: remove dead codeMax Krummenacher
2017-10-03apalis-tk1: support v1.2 hardware revisionColibri-iMX7_LXDE-Image_2.7b4-20171005Colibri-iMX6_LXDE-Image_2.7b4-20171005Colibri-VF_LXDE-Image_2.7b4-20171005Colibri-T30_LXDE-Image_2.7b4-20171005Colibri-T20_LXDE-Image_2.7b4-20171005Apalis-iMX6_LXDE-Image_2.7b4-20171005Apalis-TK1_LXDE-Image_2.7b4-20171007Apalis-TK1-Mainline_LXDE-Image_2.7b4-20171005Apalis-T30_LXDE-Image_2.7b4-20171005Marcel Ziswiler
2017-10-03apalis-tk1: rename fan enable gpio signalMarcel Ziswiler
2017-10-02colibri-imx6ull: make sure MTD partitions get passedStefan Agner
2017-10-02colibri-imx6ull: use SDP if USB serial downloader has been usedStefan Agner
2017-10-02colibri_imx7: improve DDR3 timingStefan Agner
2017-08-31colibri_imx7_emmc: add Colibri iMX7 Dual 1GB (eMMC) supportStefan Agner
2017-08-31colibri_imx6ull.c: setup all used uart to dte modeMax Krummenacher